MATCH MOUNTING

Mounting Procedures

For the proper mounting of Yokohama tires, be sure to observe some basic precautions:

  • Wheel is securely seated on the hub face.
  • All lugs have proper torque.
  • There is no buildup of dirt between the hub and wheel.
  • The wheel is not bent.
  • Both tire beads are securely seated on the rim.

Avoid scratching or bending alloy wheels during installation.

Observe match mounting procedures for safety and proper treadwear patterns.

To facilitate proper balancing, Yokohama places red and yellow marks on the sidewalls of its tires to enable the best possible match-mounting of the tire/wheel assembly. There are two methods of match-mounting Yokohama tires to wheel assemblies using these red or yellow marks:

  • Uniformity (red mark)
  • Weight (yellow mark)

1) Uniformity Method

When performing uniformity match-mounting, the red mark on the tire, indicating the point of maximum radial force variation, should be aligned with the wheel assembly's point of minimum radial run-out, which is generally indicated by a colored dot or a notch somewhere on the wheel assembly (consult manufacturer for details). Radial force variation is the fluctuation in the force that appears in the rotating axis of a tire when a specific load is applied and the tire rotated at a specific speed. It is necessary to minimize radial force variation to ensure trouble-free installation and operation. Not all wheel assemblies indicate the point of minimum radial run-out, rendering uniformity match-mounting sometimes impossible. If the point of minimum radial run-out is not indicated on a wheel assembly, the weight method of match-mounting should be used instead.

During the mounting process, proper lubrication is a must.

Lubricate both top and bottom beads with an approved tire lubricant. If the beads do not seat at 40 psi, break the entire assembly down and relubricate the bead areas.

Warning: Improper mounting, underinflation, overloading or tire damage may result in tire failure, which may lead to serious injury. Tire and rim sizes must correspond for proper fit and application. Never exceed 40 psi to seat beads.

Warning: Tire changing can be dangerous, and should be done only by trained persons using proper tools and procedures established by the Rubber Manufacturers Association. Failure to comply with proper procedures may result in incorrect positioning of the tire, tube, or wheel assembly, causing the assembly to burst with explosive force sufficient to cause serious physical injury or death. Never mount or use damaged tires, tubes or wheel assemblies.

2) Weight Method

When performing weight match-mounting, the yellow mark on the tire, indicating the point of lightest weight, should be aligned with the valve stem on the wheel assembly, which represents the heaviest weight point of the wheel assembly. After match-mounting by either of the above methods, the tire/wheel assembly can be balanced.